How to Measure for Plantation Shutters When Installing Them?
Plantation shutters are a beautiful way to add a sense of extravagance to your home. One of the initial steps to installing your shutters is to properly measure the windows that they are intended for. As you follow the steps, you need to keep in mind if the shutters are to be mounted on the inside of the window frame or the outside. The measuring techniques differ. It is also important to take into consideration the backspace as this will provide space for the louver clearance and the operation of the shutters. Make sure there is also space for hand cranks, molding, trim, and even the window itself.
Establishing the Window Squareness
Measure your window diagonally each way. In the event that there is a difference in the diagonal measurements, your window is out of square. On the off chance that the difference is less than a ¼ of an inch, you ought to be fine yet anything between ¼ and ½ is considered out of square and over ½ inches is considered greatly out of square. The established window squareness will affect the type of frame and mount that you ought to choose for your plantation shutters.
Inside Mounting Plantation Shutters
On the inside of the drywall or trim at the points where the plantation shutters will be mounted, measure for height and trim. It is important to consider if the drywall or trim narrows further back into the window opening ColbertonDemand. In the event that it does, you will want to take the narrower of the measurement to determine where you will mount you shutters. It vital that when measuring for inside mounting shutters that you measure the actual window opening and DO NOT make any deductions. The factory will make the shutters somewhat smaller than the measurements that you provide so precise measurements are important. You ought to adjust down to the nearest 1/16.
Outside Mounting Plantation Shutters
There are a few things that you should initially consider when mounting shutters on the outside of the frame. Begin by deciding how a large part of the area that you might want the shutter to cover, do not pass by the window itself. Also, decide in the event that you want the shutter’s frame mounted on the drywall, on top of the trim, or on the outside of the trim. Follow the same diagonal, vertical, and horizontal methods as given above however using the area to cover the outside as the starting and end points. On the off chance that your shutter will be mounted outside of the trim, make sure that you took into consideration the need for the shutter to clear the trim. Plantation shutter manufacturers would not take any deductions from your measurements on outside mounting plantations shutters.